A photo-etched accessory for a model of the F/A-18E Super Hornet aircraft in 1:72 scale.
Responsibility details are not available.
The F/A-18E Super Hornet is an American carrier-based multirole aircraft, the single-seat version of the larger development line derived from the older Hornet. It serves to attack ground and air targets and is one of the mainstays of carrier aviation. A model of such a machine lives or dies by its small surfaces: the grilles, hinges, straps and placards, which in plastic at 1:72 scale can only come out coarse.
The set is a photo-etched metal fret for 1:72 scale, intended for a model of the F/A-18E. Which particular parts of the model it supplements and which kit it is prepared for is given in the manufacturer's instructions; the scope of photo-etched accessories differs from one to another.
Separate the photo-etched metal parts from the fret with a sharp blade on a hard surface; nipping them off with scissors would deform them. Level off the remains of the connecting tab with a fine file or sandpaper. Run the bends along the marked lines, ideally in a bending tool or between the jaws of flat tweezers, so that the edge is sharp and straight. They are glued with super glue applied in a minute amount, and on larger areas epoxy helps. Degrease the metal before painting and apply a thin primer, otherwise the paint will rub off the smooth surface.
For modelers who want to push the level of detail at a small scale to where a plastic kit leaves off and who do not mind working with tiny metal parts.
The package contains a photo-etched fret. The model, paints, glue and tools are not included, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
