The chaff and flare dispenser for the MiG-23MLD in 1:48 scale, loaded version, is a resin accessory for building a model, not a standalone kit.
Responsibility details are not available.
A resin accessory for building a model in 1:48 scale. It replaces the chaff and flare dispenser, that is the device for releasing dipole reflectors and flares, with a fine casting in the version with loaded magazines. The base model of the aircraft is not included in the package and has to be obtained separately.
In 1:48 scale small external items are the most heavily simplified in injection-molded plastic: on such a small area it is simply not possible to draw the sharp edges of the chambers out of the mold or to suggest the individual cartridges. A resin casting fills this gap and creates, on the spine of the fuselage, one of the few points where fine detail is visible even from a distance. The loaded version corresponds to a machine ready for flight.
Wash the mold release agent off the casting, cut the casting block away with a razor saw and level the surface with sanding paper on a flat board. A smaller scale means less tolerance: dry-fit the part against the fuselage first and fill any gap with a thin strip of plastic rather than with filler, which would swallow the detail. Glue with cyanoacrylate in tiny drops applied with a piece of wire. Set the cartridges off from the body with a fine difference of shade and a thin wash; in this scale a suggestion works better than drawing out every single piece.
This is an accessory for building a model, not a standalone kit. The base model, paints and glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
