Hexagon Socket Head Cap Screws Type 1 (1.5 to 2.5 mm) is a set of 3D-printed hexagon socket head cap screws from Decalcas for superdetailing car models.
Responsibility details are not available.
This is not a kit but a set of fine imitations of hexagon socket head cap screws (type 1) intended for detailing scale models. The screws are 3D printed from resin in five diameters from 1.5 to 2.5 mm, so that you can always choose the size matching the given place on the model.
Miniature screws bring life to the places where a real vehicle is held together by visible joints, such as frames, chassis, engine blocks, body mountings and racing accessories. The parts have sharp definition of the head and do not require a primer, so that the detail is not lost; they only need to be stuck on and painted.
Separate the parts carefully from the carrier frame with a sharp knife and clean them up if needed. They are best bonded with super glue (cyanoacrylate) applied in a minute quantity. They are painted with a brush or an airbrush; a dark wash run around the head will bring out a metallic look.
This is an add-on set of parts, not a model. Glue, paints and the base model are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
