A miniature imitation of a bolted joint 0.6 mm in size, that is a nut, a bolt and a washer. An accessory for models of machinery.
Responsibility details are not available.
Parts corresponding to the three parts of a bolted joint: the bolt, the nut and the washer, in the 0.6 mm size. Compared with the bolt head alone that is a substantial difference, because a real joint is visible from both sides. Where the structure passes right through, that is on frames, brackets, the mounting of an axle or hinges, the head sits on one side and the nut with the washer on the other. A model on which this is right will stand a close look.
The size given is 0.6 mm, that is one of the small dimensions. The parts are not tied to one scale or to a particular kit; all that decides is whether the size matches the joint on the subject. Hold the part against the piece, therefore, and compare it with the surrounding shapes before you start drilling.
At this size it pays to work under a magnifier, with fine-jawed tweezers and over a light surface with a rim; a dropped part will not be found again. Sand the original suggested detail so that the part seats level. Drill the hole square and rather shallower; a deep hole swallows the part. Meter the glue with the tip of a wire into the hole, not onto the part, because a surplus around the head floods the edges and the point of the swap is lost. Install the parts only after the surface has been painted, otherwise the layer of paint fills the fine shape.
For modelers of machinery, cars and motorcycles who want exposed joints to be readable even in a close-up photograph, and for building modifications and conversions where the original surface disappears under abrasive paper. The model, paints, glue and tools are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
