Mi-17 armament pylons in 1:72 scale are a 3D-printed resin detail set from IBG. It replaces or completes the armament pylons above the side tanks of the helicopter.
Responsibility details are not available.
This is a 3D-printed resin detail set, not a helicopter model. It contains finely printed pylons for hanging armament on the Mil Mi-17 transport and assault transport helicopter in 1:72 scale, including separate struts. The parts are markedly finer than injection-molded plastic.
The pylons are fitted above the side fuel tanks on the flanks of the fuselage and carry the armament. The set is conceived as an accessory for Mi-8 and Mi-17 models in the same scale and raises the detail of the armament pylons.
Lift the parts off the print supports, wash them and separate the small struts with care. They are glued with cyanoacrylate glue. It is practical to paint the parts with an airbrush before fitting them and then to pick out the edges.
The set is supplied unassembled and unpainted. Glue, paints and the base kit are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
