A tungsten carbide scriber blade 0.2 mm wide for restoring panel lines, from the Dawning line by DSPIAE. It clamps into a holder and is drawn toward you.
Responsibility details are not available.
It is not a knife and not a drill, but a scriber blade for restoring and creating panel lines on a model. It is drawn toward you and it does not gouge the material with a point the way a needle does; it cuts with an edge, so it leaves behind a line with a flat bottom and no raised lip. The 0.2 mm width is fine and matches ordinary paneling.
The blade clamps into a holder and is guided along a metal ruler or a flexible masking template. Make the first stroke without pressure, only to create a guide groove; the following strokes deepen it. Never add pressure, it is the cutting edge that should work, not your hand. Sweep the removed material away with a brush as you go, otherwise it gets pressed back into the line under the blade. Run a fine abrasive paper over the finished line at the end so that the burr on its edges disappears.
A tungsten-based sintered material holds its edge for a very long time, but it is brittle and sideways levering will break it. This is the older of the two lines from the same manufacturer, proven and the longest-standing in the range; the shape of the blade is more straightforward and forgives a wobble less. Wipe the blade after work and store it so that the point rests against nothing.
The blade is supplied on its own, without a model and without paints.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
