A diameter of 1.5 mm, the largest size in this line. A low spread head with a straight slot for the most massive joints of a model.
Responsibility details are not available.
One and a half millimeters is the end of this sequence of sizes. On a motorcycle model in the usual scale it matches the joints that hold whole assemblies together on a real machine, that is the mounting of the swingarm, the fastening of the frame to the engine or the anchoring of a stand. Used sparingly it gives a build order; scattered over the whole surface it overloads it instead.
It is with the largest step that it shows whether the modeler had a plan. The hierarchy works when there are few of the largest heads and they lie where the real subject has the strongest joint. So go over the model before the build and mark no more than a few such places; the rest will be covered by the smaller sizes and the whole will come across as graded.
When all the heads are fitted, stand the model at the distance from which it will be displayed and look at it without a magnifier. An inconsistency in the orientation of the slots or a single missing head is far easier to see from that distance than from working distance over the bench.
The slots are usually turned either all the same way or deliberately at random. Either is defensible, but it has to be decided beforehand; half aligned and half scattered looks like an unfinished job.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
