The landing gear legs for the Su-27 1:32 are a 3D printed set of landing gear legs for a model of the Su-27 in 1:32 scale, of a strong polymer with steel reinforcement.
Responsibility details are not available.
The set replaces the nose and main landing gear legs of a model of the Su-27 in 1:32 scale. The legs are printed from a strong polymer and reinforced with steel pins, so they will carry the weight of a finished model. They capture the extended position with the hydraulic and electrical lines, the landing light and the mudguard rendered.
The Su-27 is a heavy twin-engine fighter whose main legs retract forward into the fuselage and whose nose leg retracts into the space under the cockpit. The legs carry a machine with a take-off weight of over twenty tons, so they are massive and full of struts, rods and lines. On an aircraft standing still the leg is compressed and the whole definition is clearly visible. It is precisely this detail that decides whether a model looks like a machine on the ground.
First wash the 3D printed parts in warm water with a little dish soap, so that they are rid of the residue of printing resin. Cut the supports off with a sharp blade or a fine saw as close to the part as possible and sand the marks down with your airways protected. Resin does not bond with cement for polystyrene, so use cyanoacrylate glue. Lay a thin coat of primer on before painting, otherwise the paint holds poorly on a smooth print. Glue the steel-reinforced legs into a joint that has matured and let the model stand after assembly before you set it down on its wheels.
The set is supplied unassembled and unpainted. Glue, paints and accessories are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
