0.5 mm Bullet-proof bolt - hexagonal is a set of imitation hexagonal armored bolts from Firma49. It serves to refine the surface of a model afterwards.
Responsibility details are not available.
This is a modeling accessory, not a kit. The imitation bolt heads replace the coarse molded detail that arises when injection-molded parts are made, and they add detail in places where a model has none at all. The name gives the size 0.5 millimeters, which is the finest dimension of the whole range offered.
The smallest heads suit small lids, instrument hatches, armored covers of pumps and joints on thin sheet parts. They also look good where a row of bolts is to be legible but must not visually dominate its surroundings. They will serve as well when building machinery and equipment, where bolted joints appear in large numbers side by side.
Prepare a moistened cotton swab or a stick with a little wax, with which you move the tiny part exactly into place. Pre-drill the hole with a micro drill; the head then sits square and there is no risk of it shifting at a touch. Dose the glue in a really small amount so that it does not flood the edges of the hexagon. Once dry, go over the surroundings with a fine abrasive sponge and only then apply the primer.
The accessory is supplied on its own, without a model, glue and paints.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
