A smaller photo-etched set for the cockpit of a Heinkel He 111P-1 model in 1:32 scale. Pre-painted parts for the instrument panel and the belts for a plastic kit.
Responsibility details are not available.
This is not an aircraft kit but a smaller photo-etched set, which concentrates on the most visible part of the cockpit. It contains color-printed parts with which the filling in of the dials and the lettering falls away, so that they can be used straight from the fret. Against the full photo-etched set the extent is narrower: this is not a complete fitting out of the cockpit but a quick raising of the level where it shows best through the glazing.
Cut the parts out with a sharp knife on a hard surface rather than with nippers, and make the bends along the scored line. They are glued with cyanoacrylate glue in a small amount. The pre-painted areas must not be cleaned with an aggressive solvent, as that would damage the printing. The original plastic instrument panel usually has to be sanded down so that the new part seats level. Before you glue a part permanently, try it dry and check that the canopy glazing seats once closed; photo-etched sheet is thin, but fitted a little too high it can lift a part of the cockpit.
The Heinkel He 111 was a German twin-engined bomber, and the P version was among the early forms with a fully glazed nose and Daimler-Benz engines. It is the glazing that makes the interior a visible part of the model, one on which work on detail pays off.
The set contains photo-etched parts only. The model, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
