The Eduard 1:48 McDonnell Douglas AV-8A Harrier TFace masking set is a pre-cut set of masks for the glazing of a Harrier kit in 1:48 scale, in a treatment for the outer as well as the inner side.
Responsibility details are not available.
A set of self-adhesive masks from the Czech maker Eduard. This is not a kit but an accessory that replaces the slow cutting of masking tape. The shapes are cut by machine, so they fit the frames of the glazing with no measuring up. The TFace treatment deals with the glazing from both sides.
The AV-8A was an American naval attack aircraft with vertical and short takeoff, derived from the first generation British Harrier. The thrust of the engine was deflected by swiveling nozzles, which allowed the machine to operate from small decks and improvised surfaces. The cockpit has a hinged canopy with pronounced framing.
The key to a sharp edge is pressure. Lay the mask on dry, line it up against the frame and only then press it down along the whole length of the edge with a wooden toothpick or a soft eraser — it is precisely the pressed edge that decides whether the paint runs under. On rounded canopies press from the center toward the sides, so that the paper does not ripple. Spray in thin coats perpendicular to the edge of the mask, not at a sharp angle.
A masking set is an accessory, not a kit. The model, paints and glue are not included in the package. Before buying, check that the masks match your kit.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!