The QMT 1:72 masking set for the Messerschmitt Bf 109 E-3, E-4 and E-7 is a pre-cut accessory for a plastic kit that makes spraying the canopy framing cleanly easier.
Responsibility details are not available.
This is not an airplane kit but an accessory for one. The package holds pre-cut masking shapes for a model of the Messerschmitt Bf 109 in the E-3, E-4 and E-7 versions in 1:72 scale. The set is prepared so that the individual pieces can be peeled off and stuck onto the glazed areas of the model without any tedious cutting of tape.
The canopy of the E series Bf 109 is divided by dense framing into a series of small panes, and the windshield has a geometry of its own. In 1:72 scale these are areas a few millimeters across, where trimming tape by hand directly on the model almost always shows up as an uneven edge and paint running under the mask. A pre-cut shape matches the shape of the frame, so the paint edge comes out straight and the frames stay the same width along the whole canopy.
Rid the glazing of fingerprints and grease before masking. Offer the mask up dry, press it down in the middle and only then work the edges down, with a toothpick for instance, so that no air bubble is left anywhere. Lay the paint on in several genuinely thin coats — a heavy coat creates a step at the edge of the mask. Take the mask off with tweezers at an angle, while the paint has only just dried, not after several days.
This is an accessory for a model, not the model itself. The kit, paints and glue are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!