A miter box with guide slots for cuts at 45 and 90 degrees. It leads the saw so that the cut comes out straight and repeatable.
Responsibility details are not available.
A freehand cut in thin stock almost always wanders somewhere and the joint then stays open. A miter box prevents that: the material is laid into the channel and the saw runs in a slot that holds it at a constant angle throughout the cut. Slots at ninety degrees give a square end cut, while slots at forty-five degrees let two parts be assembled into a right-angled corner without a visible gap. You will use it on plastic and wooden stock, on strip, rod and tube, that is everywhere parts are meant to follow on from each other in one plane.
Press the material against the wall of the channel and hold it along its whole length so that it does not turn in the slot. Lead the saw lightly; pressure speeds nothing up, it only bends the blade and blunts the teeth. A finely toothed modeling saw works best, as a coarse blade chips the edge of thin stock. Ease off over the last millimeters of the cut and support the part, otherwise the end will break off and leave a burr. Then true the cut face up with a file or with abrasive paper on a flat surface, and only then try the part dry.
A miter box is not a cutting mat: do not run the blade of a knife along it, as that damages the guide edges, and once a slot has spread the saw no longer holds the angle. Blow the sawdust out of the channel or sweep it out with a brush, as accumulated waste lifts the stock and the cut goes askew.
The miter box alone is supplied. A saw, a clamp, modeling material and glue are not included in the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!