The Excel Deluxe Pin Vise is a hand-held holder for small drills, and according to the name it is supplied with six drills of various sizes.
Responsibility details are not available.
A pin vise is a holder for small drills. You drill with it by hand, turning it between your fingers, with no motor and no risk of a thin drill snapping at speed or of melted plastic winding onto the cutting edge. According to the name, six drills of various sizes are part of the package.
Drilling by hand belongs to the basic outfit of a modeler in practically every field. It is used to make holes for rigging and antennas, openings for brake and fuel lines on cars, hollowed gun muzzles, holes for wire pins when joining heavier parts, and pilot holes so that plastic does not split during assembly. On parts that carry a load in particular, a wire pin glued into a pilot hole is far more reliable than glue on its own.
Mark the center of a hole first with the tip of a knife or a center punch, otherwise the drill will wander on smooth plastic. Drill slowly and without side pressure, as thin drills do not break under pull but by being pushed out of line. Support a thin-walled part with a piece of wood so that it does not break as the drill goes through. Withdraw the drill now and then and free it of swarf. Tighten the chuck only lightly after work and store the drills so that they do not knock against each other.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!