A full photo-etched set for the bomb bay of an A-20G Havoc model in 1:32 scale from the Czech manufacturer Eduard. It is not an aircraft kit but an accessory for a model you have already bought.
Responsibility details are not available.
A photo-etched set from Eduard aimed at the bomb bay of a model of the A-20G Havoc attack aircraft in the large 1:32 scale. It is a full photo-etched set, not a smaller selective version from the Zoom range. It is not an aircraft model; the parts are fitted to a kit you have already bought. Check the exact extent of the set against the instructions enclosed with it.
The Douglas A-20 Havoc was a twin-engined attack and light bomber aircraft with tricycle landing gear. The A-20G version differs from the earlier forms in its solid, unglazed nose fitted with fixed gun armament, so the center of interest shifts to the fuselage and to the bomb bay inside it. In the large 1:32 scale the inside of the bomb bay is very clearly visible with the doors open, and the smooth plastic walls from the box look empty there.
Fit the set during the build; once the fuselage is closed up you will not reach most of the surfaces. Separate the photo-etched parts with a sharp knife on a hard surface, bend them in a bender or over a steel rule and glue them with cyanoacrylate, or with two-part epoxy, which gives time to line them up. First cut away the plastic detail the photo-etch replaces and sand the surface back. Lay a filler primer on the metal before painting. Paint the inside of the bomb bay and pick the edges out with a dry brush before you close the assembly up.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
