1:32 F-15C - 3D-printed colored interior decals (Tamiya), small version from Quinta Studio offers a narrowed set focused on the most visible parts of the cockpit.
Responsibility details are not available.
The parts are 3D-printed on decal paper and are supplied already colored, so masking and spraying of small areas is unnecessary. The set is cut for the Tamiya kit in 1:32 scale. The small version designation means a reduced variant of the set with a narrower scope than the full version of the same set, so consider whether the smaller scope is enough for you.
The McDonnell Douglas F-15C Eagle is a single-seat twin-engine air superiority fighter with a large wing area, a powerful radar and an armament of a cannon and air-to-air missiles. The canopy glazing gives the pilot a view in every direction, and on a model in a large scale that means the interior stays permanently in sight.
The parts are applied to a cleaned surface coated with gloss clear, which they conform to once they have taken hold. Lay the cut-out part in lukewarm water for about fifteen seconds and slide it off the backing paper. Do not use a decal softener or a setting solution; the manufacturer rules them out, as they would attack the printed resin. Even out the base with a darker shade, work with tweezers and finish the interior before you close the fuselage and fit the canopy.
This is a detailing accessory, not a kit. The base model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
