LAST CHANCE! 20% OFF Ends Tonight!
1:32 Nakajima Ki-44 Shoki undercarriage bay paint masks

1:32 Nakajima Ki-44 Shoki undercarriage bay paint masks

6.36 €
Add to Cart

1:32 Nakajima Ki-44 Shoki undercarriage bay paint masks

Landing gear bay masks for the Nakajima Ki-44 Shoki in 1:32 scale. They close off the openings of the bays for as long as the primer and the camouflage are sprayed onto the airframe.

Scale1:32
Manufacturer Dead Design
Product EAN8591111732574

Responsibility details are not available.

6.36 €
5.26 € without VAT
In stock
Free shipping on orders over 1,000 czk in czech republic Personal pickup in Prostějov 14-day returns

About product

Nakajima Ki-44 Shoki landing gear bay masks 1:32

A masking set intended for the landing gear bays of a Nakajima Ki-44 Shoki model in 1:32 scale. The masks are inserted into the open bays and stay there throughout the painting of the outside of the model.

Where the damage arises

An airbrush does not spray a narrow beam but a cone with misting around the edges. It is precisely that fine misting which gets even where the modeler is not aiming; the air from the nozzle carries it into an open bay. The subsequent repair with a brush tends to be worse than the original mistake: thick paint from a brush has a different texture from a sprayed surface, and in a deep part you will not reach the corners anyway. A mask is therefore a simpler and quicker route than touching up later.

The real subject

The Nakajima Ki-44 Shoki was a fighter of the Japanese Army Air Force which, unlike the agile types of its day, concentrated on speed and rate of climb and was used above all for interception. The design with its short, robust fuselage and massive engine cowling is very rewarding in 1:32 scale, and the larger the model, the more every detail of the underside of the wing shows, bays included.

Usage tips

Degrease the mask and its surroundings before applying it; grease from the fingers is the most common reason an edge lifts after a while. Keep the airbrush pressure rather low; at high pressure the stream of paint bounces off the surface and looks for a way under the edge. If you paint the bay in a light interior shade and the airframe gets a dark camouflage, add one very light pass around the mask first; any bleed will then not look like a sharp line on a light base. Remove the mask while the top color is only just set.

Who the set is for

  • Builders of the Ki-44 Shoki in the largest common scale
  • Modelers who paint interiors before closing them and want to protect them
  • Those who want to avoid brush touch-ups in deep parts
  • As part of the complete preparation of a model together with other masks

Reviews

No reviews yet Have you built this one? Tell other modellers how it went and help them choose.

Forum

Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.

Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.

There are no questions here yet. Be the first to ask!

FAQ

Foam does not follow the edge of the opening exactly and the paint gets inside around it. A die-cut mask fits the shape of the bay and holds a crisp edge.

Once the last coat has set. There is no need to leave it on the model until the paint has cured fully, and the edge then separates less easily.

That is not its purpose. The shapes are cut for the bays of the Ki-44 Shoki in 1:32 scale.

Last seen

Dead DesignUC320051:32

1:32 Nakajima Ki-44 Shoki undercarriage bay paint masks

Landing gear bay masks for the Nakajima Ki-44 Shoki in 1:32 scale. They close off the openings of the bays for as long as the primer and the camouflage are sprayed onto the airframe.
In stock
6.36 €
PANZER ARTFI35-0241:35

1:35 British RAC officer North Africa No.1

1:35 British RAC officer, North Africa, number 1 is a separate resin figure of an officer in tropical dress. It fills out a British armored vehicle in 1:35.
In stock
13.96 €
SBS ModelSBSD480421:48

1:48 Eino Luukkanen - Finland’s Top Ace WW II Vol.III

A decal sheet in 1:48 scale devoted to the Finnish fighter pilot Eino Luukkanen. The third part of a decal line on Finnish fighter aces of the Second World War.
In stock
10.76 €
1:48 F-14D 3D-Printed & coloured Interior on decal paper (Hobby Boss)-25 %Stock ClearanceFavorite
Quinta StudioQD484051:48

1:48 F-14D 3D-Printed & coloured Interior on decal paper (Hobby Boss)

Colored three-dimensional interior elements from Quinta for the F-14D in 1:48 scale, prepared for the Hobby Boss kit. They are applied by the wet method.
3 leftof 5
36.76 €27.56 € You save 9.20 €
Voyager ModelPE354871:35

1:35 WWII German VsKfz.617 (For MENG SS-001)

Voyager Model, a photo-etched set for the German VsKfz.617 in 1:35 scale. Brass photo-etched parts to raise the detail of the German mine-clearing vehicle of the Second World War. The target kit is the Meng SS-001.
In stock
11.56 €
Exotic DecalsEXOT480051:48

1:48 Bulgarian Arrows #2 Bf 109E-3 in Bulgarian service

A sheet of decals in 1:48 scale with Bulgarian markings for the Messerschmitt Bf 109E-3. The second installment of a series devoted to aircraft in the service of the Bulgarian Air Force.
In stock
11.96 €
Mf zoneMFZ-DC24731:24

1:24 Lancia Delta S4 Decals for model kits Beemax and NUNU

A decal sheet for a model of the rally car Lancia Delta S4 in 1:24 scale, prepared for the kits of the brands Beemax and NUNU.
In stock
15.56 €
1:35 Německá nádoba na vodu - 18 l
-20 %
Favorite
PlusmodelPMOEL0131:35

1:35 Německá nádoba na vodu - 18 l

A set of six castings of the German field water container with a capacity of eighteen liters, 1:35 scale. A load for a truck bed and equipment for a supply post.
In stock
3.96 €3.17 € You save 0.79 €
FujimiFU046771:24

1:24 Scale Fujimi Toyota Drift King AE86 Trueno Tohge Easy Alignment System

Toyota Drift King AE86 Trueno Tohge is a model of a compact Japanese coupe with pop-up headlights, worked out in 1:24 scale.
In stock
35.16 €
Loading, please wait...

Setting consent to personalization

With your consent, we may use the information below for the following purposes or share it with selected partners. You can adjust your settings for individual purposes (types of processing) and confirm your choice with the "Save settings" button:

Always active

Necessary cookies

These are technical files that are necessary for the correct behavior of our website and all its functions. They are used, among other things, to store products in the shopping cart, display products on request, control filters, personal settings and also set consent to the use of cookies. Your consent is not required for these cookies and it is not possible to remove it.

Analytical cookies

They count website traffic and, by collecting anonymous statistics, enable the operator to better understand their visitors and thus constantly improve the site.

Marketing cookies

They collect information to better tailor advertising to your interests, both on and off this website.

Setting consent to personalization

To make it easier for you to browse the site, to offer you customized content or advertising, and to analyze traffic anonymously, we use cookies that we share with our partners for social media, advertising, and analytics. You can adjust their settings with the "Edit settings" link and you can change it at any time in the footer of the website. You can find more detailed information in our Policy on the protection of personal data and the use of cookies.