Die-cut masks for the glazing and the wheels of the large model of the naval Hurricane Mk.IIc fighter from the Revell kit.
Responsibility details are not available.
The cockpit of the Hurricane was closed by a sliding canopy made up of several flat panes in a dense frame, and ahead of it stood a V-shaped windscreen with an armored panel. The designer Sydney Camm did not bet on rounded shapes but on simplicity of manufacture: flat glass does not have to be curved and a mechanic can replace a damaged pane on deck in a few minutes. Over fourteen thousand Hurricanes were built, and for service at sea finished airframes were converted, so the shape of the glazing stayed the same as on the land version. For a modeler, though, that means a great many narrow frames which have to be separated from the clear area, and at 1:32 scale there is a respectable row of them on the canopy and the windscreen.
With glazing as intricate as this, hand-cut tape almost always slips somewhere and the paint creeps under. Die-cut masks sit exactly to the shape of the frame, hold by themselves and leave no adhesive residue when removed. The material is a fine paper with a flexible layer, which follows the slight curve of the glass and does not lift at the corners.
Lift a mask with the tip of a scalpel, transfer it with tweezers and press it down with a soft wooden stick from the center to the edges. Apply the paint in thin coats, so no ridge forms on the edge. Remove them shortly after the last coat has dried, while the finish is still flexible. Besides the glazing, the set also holds circular masks for the wheel hubs, thanks to which the tire stays separated without laborious outlining with a brush.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!