A dark blue modeling wire for detailing. It serves to imitate wiring, hoses and lines in engine bays, landing gear bays and interiors.
Responsibility details are not available.
Dark blue wire is a universal material for detailing models. A modeler uses it in place of wiring, hydraulic and fuel lines, hoses and leads, that is everything that in reality runs from one place to another and that is usually missing in the box with a kit. It is exactly these lines that give finished work its depth, because the eye reads them as a familiar detail from a real machine.
Most often in engine bays, in landing gear bays, on instrument panels and in interiors. It finds a use on aircraft, vehicles and figure scenes, and the scale is not limited in any way: the same wire will serve as a thick bundle in a small scale and as a thin hose in a large one. It also suits lines run along bulkheads, where the material has to be thin and yet shapeable.
Unwind the length you need, straighten the wire by pulling it between your fingers and shorten it with side cutters. Insert the ends into pre-drilled holes; they hold best that way and the joint is not visible. It is glued with super glue applied in a minute amount, and on larger areas PVA glue will do. Make the bends over a round tool, so that a natural curve arises rather than a sharp kink.
The color in the material is usually enough and a coat is not needed. If you want one all the same, degrease the surface first and use a primer. Glue, paints and other material are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!