Copper State Models 1:35 Fahrpanzer Doors is a resin set of doors for a model of the Fahrpanzer mobile armored turret in 1:35 scale: an accessory for the basic kit, not a standalone model.
Responsibility details are not available.
A resin accessory from Copper State Models: separately cast doors for a model of the Fahrpanzer in 1:35 scale. This is not a model of the vehicle but a replacement part for the Fahrpanzer kit from the same maker. Separately cast doors have a finer shape than a part that has to come out of a split mold, and above all they give you the freedom to choose the position you seat them in on the model.
The Fahrpanzer was a small armored turret with a gun, produced at the end of the nineteenth century at the Gruson works in Magdeburg. It was not a vehicle in today's sense: the turret was moved on rails or on a cart to an appointed position in a fortification and was seated there. The crew entered it through exactly these doors at the rear. The design lived to see the First World War and is one of the oldest forerunners of armored equipment a modeler will come across.
Wash the resin parts in lukewarm water with detergent, so that no mold release agent stays on the surface. Cut the casting block off with a saw or a knife, not with nippers. Sand wet and with your airways protected. They are glued with super glue. Before you glue the doors on, dry-fit them and think the position over, because open doors reveal what is inside, so the inside has to be painted in advance. Around old armored structures a discreet rust and streaking suits well rather than exaggerated corrosion.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!