The printed accessory 1:35 Printed Accessories: Wall and Floor Tiles Nr.13 from RT-Diorama brings a subject of wall and floor tiles for interiors in a diorama in 1:35 scale.
Responsibility details are not available.
The set 1:35 Printed Accessories: Wall and Floor Tiles Nr.13 from RT-Diorama is a printed diorama accessory, not a kit and not a finished model. It bears a subject of wall and floor tiles for interiors at a size of 1:35 and belongs to a range numbered as it goes along, in which every number corresponds to a different pattern. Tiles are at the same time one of the few elements the eye checks at once - a regular grid gives away every inaccuracy, and that is why a printed solution pays off more than painting by hand.
Typically in an entrance hall, a corridor, a kitchen, factory back rooms or a public building, that is anywhere a wooden floor would make no sense. It also works well in a partly demolished interior, where only part of the tiling is visible and the rest disappears under rubble.
Keeping things parallel is the key: line the grid up with the edge of the wall, not with the edge of the base, or the room will come across as skewed. You will trim the area more accurately if you run the cut along a joint. Under the furniture and at the foot of the wall it pays to leave an overlap, so that no light gap is left anywhere. Finally darken the joints with fine dust - it is precisely in them that dirt collects in reality, and without that a floor looks freshly laid.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
