1:48 F-15C 3D-Printed & coloured Interior on decal paper (Academy) (Small version)

F-15C - 3D colored interior 1:48

A set of colored 3D decals from Quinta Studio for raising the level of detail in the cockpit of the American F-15C Eagle fighter in 1:48 scale. The elements are printed on a flexible film, carry a raised relief and are applied as a wet decal: after about fifteen seconds in lukewarm water they slide off the backing paper. They have no adhesive layer of their own; they hold on gloss varnish (Future, Klear, Tamiya X-22). These are not photo-etched or resin parts. This smaller version holds the basic set of elements for the cockpit. The set is intended for models of the F-15C fighter in this scale. The decals are shaped to the parts of the Academy kit.

What the set contains and what it is for

The instrument panel, the side consoles and the interior panels are reproduced with faithful colors, lettering and a raised relief on the controls. The flexible film settles even on intricate and slightly curved surfaces, where a drop of gloss varnish helps adhesion, and it creates the impression of three-dimensional equipment in the cockpit without laborious painting.

Use

• Clean and degrease the interior surfaces of the model and go over them with gloss varnish
• Dip the element in lukewarm water for fifteen seconds and slide it off the backing paper onto the panel
• Fine-tune the position while the element still slides; on intricate spots a drop of cyanoacrylate glue helps
• Suitable for more advanced modelers with experience in detailing

Who the set is for

For modelers who want to get a colored three-dimensional cockpit of the F-15C fighter in 1:48 scale quickly.

This is an accessory for a build. The base model, the paints and the glue are not included in the package, unless stated otherwise.