Eduard 1:48 A-7A/B exterior is a set of photo-etched parts in brass for detailing the exterior of the carrier-based attack aircraft Vought A-7 Corsair II in the A and B versions in 1:48 scale.
Responsibility details are not available.
This is a set of photo-etched parts in brass for detailing the exterior of the carrier-based attack aircraft Vought A-7 Corsair II in the A-7A and A-7B versions in 1:48 scale. It is not a model of the aircraft but an exterior accessory for a plastic kit.
The set holds photo-etched exterior parts for the Vought A-7 Corsair II model (the A-7A/B versions) in 1:48 scale - typically various covers, panels, grilles, bracing, static dischargers and other fine outer elements that raise the fidelity of the surface of the airframe. It fills out the plastic casting with details that injection molding cannot reach.
The Vought A-7 Corsair II was an American subsonic carrier-based attack aircraft, which came from the design of the F-8 Crusader fighter. The early A-7A and A-7B versions served with the Navy and proved themselves in combat in Vietnam thanks to their large weapon load and good range.
Separate the parts carefully with a sharp knife or with photo-etch shears, make the bends along the engraved lines, ideally in a bending tool, and glue them with super glue (cyanoacrylate) or epoxy. Degrease the surface before painting; photo-etched parts hold paint better once a base primer has been sprayed on.
This is a separate set of photo-etched parts, an accessory, not a model of the aircraft. The plastic kit, glue and paints are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
