1:48 Curtiss P-40E Warhawk 1000lb US bomb is a resin ordnance accessory from the Czech maker Eduard that the modeler swaps for the matching plastic kit part.
Responsibility details are not available.
A small resin accessory set in 1:48 scale from the Czech manufacturer Eduard. The content is an American aerial bomb carried under the fuselage of the P-40E. The casting offers a finer surface, sharper edges on the tail fins and a more faithful body profile than an injection mold can manage.
With an Allison V-1710 engine and six 12.7 mm machine guns, this machine was among the most widespread American fighters of the first war years. At high altitude it fell behind its rivals, but down low it did well, which is why units in the Pacific, over North Africa and over China sent it mainly against ground targets. A pylon under the fuselage belonged to that work as naturally as the machine guns in the wing.
First wash the casting in lukewarm soapy water so that no mold release layer stays on the surface. Separate the casting block with a saw or a sharp knife and level the area with abrasive paper; protect your airways when sanding resin. The joint holds reliably with cyanoacrylate glue. Before spraying it is worth laying down a thin primer, on which the shade then sits evenly.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
