1:48 Mitsubishi A6M2 Zero landing flaps 3D PRINTED

A6M2 Zero landing flaps (1:48, Eduard)

This is a 3D printed resin detail set from the Brassin line, not an aircraft model. The set replaces the plastic landing flaps of the Japanese Mitsubishi A6M2 Zero fighter with a truer rendering of their internal rib structure and is intended for A6M2 kits in 1:48 scale from the manufacturer Eduard. The flaps can be fitted in the lowered position, which gives a model on its stand a livelier look. Alongside the 3D printed parts there is usually a small photo-etched fret for the finest details.

The real subject

The A6M Zero was the standard carrier fighter of the Imperial Japanese Navy Air Service during the Second World War. It was famous for its exceptional range and agility, paid for by a light structure without armor. Lowered flaps reveal the internal structure of the wing, which is only suggested in plastic.

Use and fitting

• Check that you are building the A6M2 in 1:48 scale from Eduard, as the set is shaped for this kit.
• Wash the parts in lukewarm soapy water to remove print resin residue.
• Cut the print supports off carefully; a 3D print is brittle, so never break it off.
• Sand the marks with respiratory protection, ideally wet.
• Bond with super glue (cyanoacrylate); fix the photo-etched parts with super glue as well.

Who the set is for

For modelers building the Eduard A6M2 Zero who want to bring out the opened wing with lowered flaps. Working with 3D printed resin calls for care and super glue.

The accessory is supplied unpainted. The base kit, paints and glue are not included in the package. Use a respirator and ventilate when sanding resin.