The warning cones Green Stuff World 1:48 Traffic Cones are 3D-printed resin parts for dioramas in 1:48 scale.
Responsibility details are not available.
Small warning cones are among the most overlooked and yet the most effective props of a scene. They are made by printing in resin, which manages a thin wall as well as a rounded tip, and in 1:48 scale they measure only a few millimeters. That is exactly why it pays to take them off the frame over a pad, so that a small piece does not get lost.
On an airfield apron around a parked machine, beside a mobile set of boarding steps, in front of the gate of a base, on a construction site, at a checkpoint or at the scene of an accident. A line of cones set out creates a corridor and thereby forces a story on the scene without needing a single extra figure. A pair of cones by rails or by a raised hood suggests work in progress.
Real cones tend to be a saturated orange or red with a white reflective band. The surest procedure leads through a white base, over which the color keeps its saturation; the band is then masked off and gone over. The lower edge deserves a cast of gray and mud, because a cone stands on the ground and tends to be clean only the day after it was unpacked. A matte varnish unifies the surface and rids the part of the gloss of the print. A cone knocked over on its side then gives a scene a sense of haste and movement.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
