Double organizer for workbench is a printed Rattlesnake product holder for two bottles thirty-five millimeters in diameter, that is for the usual Ammo by Mig Jimenez containers.
Responsibility details are not available.
A small holder made by three-dimensional printing takes two bottles thirty-five millimeters in diameter. Most Ammo by Mig Jimenez containers have this dimension, that is glues, pigments and decal products. The manufacturer describes it as a practical and safe place to set bottles down on the workbench.
A tall narrow bottle tipped over on the bench means pigment spilled among the parts laid out there, or a puddle under a build in progress. An anchored bottle can be opened and closed with one hand, which you will appreciate at the moment the other one is holding a part. Two seats side by side also keep together a pair that is usually used together, a pigment and its fixer, for example.
The component is printed rather than cast, so the print layers may be visible on the surface. If they bother you, go over them with fine sandpaper and perhaps spray them with a filler primer. Leave solvents open for as short a time as possible and close the bottles after work, because the plastic of print resins is not resistant to all chemicals.
Chemicals and glues are not supplied with the holder. If you plan to glue the holder down permanently, try the bond in a hidden place first, because the surface of a printed part reacts differently to different glues.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!