A cut masking set for the cockpit glazing of the Japanese Aichi M6A1 Seiran floatplane bomber in 1:48 scale. It replaces laborious scribing of the frames with a scalpel and gives the spray a sharp edge.
Responsibility details are not available.
The Aichi M6A1 Seiran arose as a weapon without parallel: a folding twin-float bomber that fitted into the cylindrical hangar of a Japanese I-400 class submarine. The crew was to unfold the machine after surfacing and launch it from a catapult within a few minutes. Just under thirty were completed and the intended strike on the Panama Canal never took place in the end.
The cockpit glazing on this machine is long, divided into a row of sections, and the frames between them are thin. Scribing them along adhesive tape can easily take an hour and a single slip means a scratch in the clear part. Ready-made cut shapes do away with that step and the edge of the spray comes out sharp.
Apply the paint in several light coats; creeping under the edge almost always comes from a single wet coat sprayed from close up. Lift the film while the paint is freshly set, with the tip of a toothpick or with fine-jawed tweezers.
In this scale the Seiran is one of the larger single-engine machines and its floats offer a broad continuous area on which every uneven edge shows at once. It therefore pays to lay the primer down first, look along the edges against the light and only then go on with the color coats. Keep the remnants of the carrier sheet, they will serve for covering the struts between the floats and the fuselage.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!