Cut masks for spraying the markings and the glazing on the large Spitfire Mk.VIII kit from Tamiya. A crisp transition of paint without the border a decal leaves behind.
Responsibility details are not available.
The Mk.VIII was designed as a properly strengthened version for fighting at high altitude, and with a tropical filter under the engine it went off to where the war was fought in dust and heat: to Italy, over Burma and to the Australian squadrons in the Pacific. Against the hastily adapted Mk.IX line it had a strengthened fuselage, a longer-travel landing gear and, from the middle of production, a clipped wing as well, which at low levels made it a more agile opponent. It is on machines like these that the national insignia tend to be largest and most visible; at this scale a roundel takes up an area where every imperfect decal edge already offends the eye.
The set gets around that problem. The mask is stuck onto the finished paint, the color is sprayed straight through it, and once it is removed a marking is left that cannot be told from the finish even in sharp raking light. The modeler can moreover mix the tone of the marking himself and bring it into line with the shade he has used on the model.
Before you start spraying: degrease the area, press the mask down from the center toward the edges and apply the paint at right angles, not at an angle under the edge. An angled spray will run under the edge and blur the outline the set is meant to guarantee.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!