Exhaust nozzles for the MiG-29 in 1:72 scale from Eduard. A resin set made by direct 3D printing, faithful engine nozzles to replace the plastic parts.
Responsibility details are not available.
A detailed set of exhaust nozzles for the Soviet MiG-29 fighter in 1:72 scale from Eduard. The parts are made by direct 3D printing with the faithful inner and outer structure of the nozzles, which injection-molded plastic usually cannot capture in this scale. The set replaces the plastic nozzles of the base kit and is intended for MiG-29 models.
The MiG-29 Fulcrum is a twin-engine frontline fighter powered by two jet engines. The exhaust nozzles are among the prominent features of the rear end of the aircraft and rendering them faithfully lifts the overall impression of the model considerably.
Separate the nozzles from the print supports and clean them up. Bond with super glue. For a faithful look, combine metallic and heat-discolored shades, and finish with pigments if you wish. Protect your airways while sanding.
This is an accessory set, not a complete airplane model. Glue, paints and the base kit are not included in the package.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
