1:72 Zlin Z-50 vacuum-formed canopy is an accessory to a kit you have already bought, not an airplane model: a clear cockpit canopy for the Zlin Z-50 aerobatic aircraft in 1:72 scale.
Responsibility details are not available.
This is a replacement clear part for the model you are building, not an aircraft kit. A vacuum-formed canopy is made by drawing thin clear film over a form, so it has a markedly smaller thickness and better optics than the injected part from the kit. The set from the Czech maker Brengun is cut for the Brengun kit.
The Zlin Z-50 is a single-seat aerobatic aircraft developed in Czechoslovakia in the 1970s. It is an all-metal monoplane with fixed landing gear and a radial engine, designed from the start for competition aerobatics. Its cockpit is exceptionally visible: the pilot sits high, the glazing is large and reaches far to the rear, so the thickness and the clarity of the canopy tell on a model at once.
An injected clear part has to be thicker because of the mold and its inner and outer radii differ, so the edges of the frames look massive and the view into the cockpit is distorted. Drawn film is thin and optically clean, and once masked the frames read like the real strips of the glazing. The canopy can also be fitted in the open position without trouble, which makes sense on a model with a well-worked interior.
Do not hurry. Cut the canopy out with a margin of a few millimeters around the outline, then gradually sand the remaining film down on fine-grit abrasive paper laid flat, until the edge seats exactly on the fuselage. Test the fit dry as you go. Protect the inside from fingerprints, ideally by leaving the protective film on the part or filling it with a piece of cotton wool. It is glued with white glue for clear parts, which turns transparent once dry and does not fog the surface; the fumes of super glue cloud the film. Mask the frames with narrow strips of tape or with liquid mask and paint in thin coats. Small scratches on the outside can be polished out with abrasive compound or removed by dipping it in clear gloss varnish.
This is an accessory, not a kit. The model, glue, paints and masking material are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
