1 mm Nut with bolt shank is a set of small modeling nuts with a length of shank in the 1 mm size designation. It replaces a molded screw joint on a model of a vehicle.
Responsibility details are not available.
Small modeling nuts with a projecting length of shank, with the size designation 1 mm. It is not a kit or a finished model but an accessory with which a flat molded joint on a model is replaced by truer three-dimensional detail.
A nut with the end of a bolt passed through it is one of the most frequent details on vehicles: it holds gearbox covers, brackets, lifting eyes, fenders and the mounting of equipment. On injection-molded plastic it tends to be suggested only by a shallow projection with no visible threaded end. A separate part adds a surface on which the light breaks, and a row of such joints can visually transform a whole side of a hull or an engine cover.
Cut the original projection off with a scalpel and level the surface with a sanding sponge. Drill the hole with a micro drill in a hand holder, and preferably in two passes, with a smaller and then the final diameter. Set the part in with tweezers or a dampened brush and secure it with a minimal drop of cyanoacrylate glue, as excess glue will show under the paint as a glossy patch. Once it has cured, spray the surface with a primer to bring the finish into line. Finally pick the detail out with a dark wash, which will run in around the nut.
This is an accessory for the build of a model, not a model on its own. The kit, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
