The plastic sheet 1.0 mm from Evergreen is a thick white polystyrene sheet of roughly 15 x 30 cm, suitable for load-bearing parts and base plates.
Responsibility details are not available.
A white opaque polystyrene sheet one millimeter thick and roughly fifteen by thirty centimeters in size. There are two sheets in the package. It is the thickest of the commonly used gauges for modeling work: the sheet holds its shape on its own and takes a load, so structures can be built from it, not only skins.
Do not cut this gauge in a single pass. Score it several times along a ruler and then snap it over the edge of a table, and level the edge afterwards with a sanding pad or a file. When gluing large areas, apply the cement over the whole mating surface and weigh the sheet down so that the joint does not ripple. A white fracture line is visible on a cut edge, so sand and fill it before painting.
Two layers glued together give a sheet of double thickness that does not warp even at larger sizes. Weigh the joint down after it has dried, until the cement has fully cured.
When cutting, work with a sharp knife on a cutting mat and do not inhale the sanding dust.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!