Air output fine-tuning valve is a valve for the fine adjustment of air output in an airbrush setup from the manufacturer U-STAR. It goes into the air line and makes it possible to set the flow more precisely.
Responsibility details are not available.
An airbrush accessory from the manufacturer U-STAR. The valve goes into the air line and serves for the fine adjustment of the amount of air that reaches the airbrush. It is not the airbrush itself or a compressor but an accessory that gives better control over the setting right at hand.
The main pressure setting belongs on the compressor or on its regulator. During work, though, you often need only to take a little off or add a little, for instance when moving from a primer coat to fine transitions, when spraying a small part, or when the paint starts drying on the nozzle. Fine adjustment right in the hose is considerably more convenient at such a moment, and above all it does not interrupt the job in hand.
Before you buy, check how your setup is connected and what fittings it has; compare the size of the thread against the data on the box. After fitting it, check the joints for leaks — escaping air can be told by a hiss and by the compressor cutting in more often than usual. And remember that the valve by itself is no substitute for thinning the paint properly: most spraying problems originate in the paint, not in the air.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
