A stencil for spraying with an airbrush. It transfers a repeated pattern onto a model, onto the terrain of a diorama and onto a base.
Responsibility details are not available.
A spray stencil is a simple aid with a large effect: you lay it on a surface, spray over it, and exactly the pattern cut into the stencil is left on the model. Painting the same motif by hand with a brush takes many times longer and only rarely comes out as regular. It suits the surfaces of vehicles and aircraft, the terrain of a diorama and bases and backdrops, where a repeated texture is meant to show.
Lay the stencil on only once the base coat has dried through and hold it so that it lies flat over the whole area; wherever it stands off, the paint will creep under. Spray at low pressure, perpendicular from above and in thin coats, rather in several passes. A wet coat creeps under the edges and smears the edge of the pattern. Once it is removed, the motif can be repeated alongside or layered over itself in a different shade, which creates the impression of an irregular, long weathered surface.
Try the pattern on a piece of plastic or on card first, and only then go to the model. Clean the stencil after work while the paint is fresh; dried paint clogs the cut-outs and the drawing is then lost. Keep it flat so that it does not warp. The particular motif of the cut-outs, the size of the sheet and the recommended use are given by the manufacturer.
A stencil is supplied. Paints, a model and an airbrush are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
