Wheel chocks for an aircraft in 1:48 scale, version four, measuring 11 x 5 x 6.5 mm. The set holds four pieces and a decal.
Responsibility details are not available.
Wheel chocks are pushed against the wheels of an aircraft as soon as it stops on an apron, and are taken away only before taxiing. On a model they are details that stand at ground level with the viewer's eye right on them, so it pays to do them carefully. Version four has a stated size of 11 x 5 x 6.5 mm, which in 1:48 scale corresponds to a piece that in reality would be a little over half a meter long.
Four chocks and a decal. Decals are usually transferred the wet way: the motif is cut out, dipped briefly in water and, once free of its carrier, slid onto a dampened spot, where the water is pressed out with a soft cloth. Before you soak the sheet, check in the instructions whether it is not a self-adhesive version, because a soaked self-adhesive film is ruined beyond repair.
At eleven millimeters long, the chocks are handled with tweezers, not fingers. Prepare a working surface with a raised edge so that a part that springs away does not vanish on the floor. Wash and degrease the parts before painting and paint them before you seat them on the model. Choose the glue according to the material of the parts; on a smooth, non-absorbent surface cyanoacrylate glue holds more reliably than polystyrene cement. Apply it with the head of a pin, as a drop from the bottle is too much for a part this small and will run onto the surrounding surface.
The package contains chocks and a decal. The model, a base, paints and glue are not included, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
