A replacement tail rotor for models of the MH-60L and UH-60A helicopters in 1:48 scale, cut for the ICM kit.
Responsibility details are not available.
An accessory set with a replacement tail rotor for models of the MH-60L and UH-60A helicopters, that is, machines of the Black Hawk family, cut for the ICM kit in 1:48 scale. It replaces the tail rotor from the kit with finished parts.
The tail rotor of the Black Hawk is not just a vertical propeller: it carries four blades and is canted relative to the vertical tail, so modeler and layman alike recognize it in the silhouette of the machine. It is at the same time the thinnest place on the model. The blades of an injection-molded part tend, because of the mold, to be thicker than the scale would call for, and the rotor head stays simplified. The replacement part holds the thin section of the blade and the intricate head, where the individual hinges and control rods are visible.
The blades are dark and smooth, so every layer of paint shows on them. Spray them evenly and matte, otherwise they will shine where they curve. On a machine in service the leading edges are worn by dust and sand, which can be suggested with a thin light abrasion along the edge and a gentle pull of the edges with a dry brush. The real machine carries markings on the blades too, but look for their form in references for the particular aircraft.
For builders of the Black Hawk in 1:48 scale from the ICM kit who are bothered by thick blades and a coarse rotor head. The kit, paints and glue are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
