The FAB-3000 high-explosive bomb in 1:72 is a 3D-printed armament set for models of Russian combat aircraft. It fills out the stores of a finished kit.
Responsibility details are not available.
An add-on set in 1:72 scale from the Russian manufacturer Temp Models, printed from photopolymer. The contents are a high-explosive aerial bomb of the 3000 kilogram weight class, that is one of the largest weapons a tactical air force carries. The set is hung under a finished model and does not make up an aircraft model on its own.
The FAB-3000 is a Soviet and Russian high-explosive aerial bomb of the 3000 kilogram weight class. It works purely by blast and is intended against fortified and large structures for which a smaller class would not be enough. Given its weight only some combat aircraft can lift it, and always one round on a load-bearing hardpoint, so on a model it stands out as the dominant feature of the load.
The parts are printed from photopolymer, so thin print supports are left on them. Cut them away with a sharp scalpel or photo-etch nippers and sand the pad they leave with fine abrasive paper. They are glued with cyanoacrylate glue, that is with super glue, because polystyrene cement has no effect on this material. Lay down a filler primer before painting; it will at the same time reveal any remains of the supports. Sanding is best done wet and with respiratory protection.
The set is supplied unassembled and unpainted. Glue, paints and the base model are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
