Wheels for the Su-24, 1:48 is a 3D-printed resin set of landing gear wheels for a model of the Su-24 tactical bomber in 1:48 scale.
Responsibility details are not available.
This 3D-printed resin set replaces the landing gear wheels of a Su-24 model in 1:48 scale. The wheels are modeled with the flat spot that the weight of the aircraft presses into the tire, and on this machine it is considerable. It is not an aircraft model but a replacement for the simplified parts from the kit.
The Su-24 is a Soviet tactical bomber with a variable-geometry wing and a crew seated side by side. It was built to operate from less prepared surfaces as well, so it has sturdy landing gear with a pair of wheels on each main leg and low-pressure tires. On a parked machine the tires are clearly settled and dusty from the concrete surface. It is this detail that does the most for a finished model.
Wash the 3D-printed parts in warm soapy water first, to get rid of any print resin residue. Cut the print supports off with a sharp blade or a fine saw as close to the part as you can and sand the marks away with respiratory protection. Resin does not bond with polystyrene cement, so use cyanoacrylate glue. Apply a thin coat of primer before painting, otherwise the paint will not hold well on the smooth print. Fit the wheels with the weighted deformation so that the flattened area of the tire sits on the base, otherwise the model will not stand naturally.
The set is supplied unassembled and unpainted. Glue, paints and accessories are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
