Landing gear legs for the MiG-29K in 1:48 scale are a 3D-printed resin accessory from Temp Models, reinforced with steel pins.
Responsibility details are not available.
A resin set of landing gear legs for a model of the MiG-29K carrier fighter in 1:48 scale from the Russian brand Temp Models. For the sets in this series the manufacturer states printing from a strong polymer reinforced with steel pins, and the extended position with the lines, the landing lights and a fender picked out. Plastic legs sag in time under the weight of a finished model; here that problem falls away. It is not an aircraft kit but replacement parts.
The MiG-29K is the carrier version for operation from an aircraft carrier. It launches over a ski-jump ramp and lands onto arresting wires, so the landing gear takes incomparably harder treatment than on a land-based machine: the aircraft touches down with its full weight and without a flare. The structure of the legs is therefore reinforced and it differs from the land-based version, which is clearly visible on a model.
Release the parts from the supports with a scalpel and level the mating faces. Wash the resin in lukewarm soapy water before painting. Spray the legs before fitting and bring the lines out with a dark tone run into the recesses. On carrier hardware, weathering that leans toward gray suits the model, matching the salt haze, with a hint of corrosion on the edges.
The set is supplied unassembled and unpainted. The model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
