20% OFF Sale Until Wednesday!
MASTER • KELIK • RESKIT • QUINTA STUDIO • EDUARD • GUNZE • VALLEJO • HGW • DEAD DESIGN • FIRMA49 • KOVOZÁVODY PROSTĚJOV • AZ MODEL • RS MODELS
Sale Ends Wednesday, November 11, 2026!
The Tamiya Fine Pin Vise D (0.1-3.2 mm) is a hand chuck (a drill bit holder) for drilling accurate holes in models.
Responsibility details are not available.
The Tamiya Fine Pin Vise D is a good-quality hand chuck, that is a holder for modeling drill bits. It takes bits from 0.1 to 3.2 mm in diameter, so it covers a wide range of the holes needed during a build. The top end swivels, so that the tool can be guided comfortably between the fingers and the drilling stays even. Drilling is done by hand, without a motor, which gives full control over both the depth and the position of the hole.
For modelers of all levels who need to drill holes accurately and safely when detailing plastic models. Drill bits are not included in the package, unless stated otherwise.
Drill bits are sharp and brittle. Work carefully, protect your eyes and keep the tool out of the reach of children.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
