M3A4 is a set of photo-etched parts in 1:35 scale from the Czech manufacturer Eduard. It is not a model but an accessory for refining the detail of a finished kit.
Responsibility details are not available.
This is a set of photo-etched metal parts in 1:35 scale, not a kit. Its purpose is to replace, on a plastic model of American Second World War equipment designated M3A4, the parts that cannot be molded thin enough in plastic. It is a full photo-etched set, not the smaller pre-painted Zoom set.
Etched sheet is an order of magnitude thinner than injection-molded plastic, so it allows convincingly thin fender edges, grilles, brackets, tool clamps, clasps and similar small items. It is in exactly these places that the difference between a model built from the kit and one supplemented with photo-etched parts shows most, especially seen from the side and from above. The set is intended for a particular kit; the name does not give it, so compare which M3A4 model you are building before buying.
Cut the parts off the fret with a sharp scalpel or photo-etch shears against a hard surface, not with pliers. Make the bends in a bending tool or between two blades, so the edge comes out straight. Glue the metal with super glue; on larger areas a glue with a longer setting time helps, since it gives you time to seat the part. Degrease the sheet before painting and spray it with a primer, otherwise the paint will not hold on smooth metal. Thicker parts can be warmed briefly before bending, which softens them and stops them springing back.
This is an accessory for a model. The kit, the glue and the paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
