Tungsten Steel Panel Line Scriber Push Broach .4 Chisel 0.4mm

DSPIAE scriber with a 0.4 mm chisel edge

A tungsten steel tool with a flat edge 0.4 mm wide, which is guided over the surface in one direction and removes material rather than pushing it aside. A width between the finest and the middle values of the range is a compromise for lines that should read clearly once highlighted but still not look coarse.

How it differs from improvised solutions

Most modelers start with the back of a scalpel, a compass needle or a snapped-off piece of saw blade. All these substitutes share one weakness: they have no defined width of cut. The groove widens according to how hard you happen to be pushing and at what angle you hold the tool, and over a long stroke it shows. A tool with an edge ground to a given width removes that variable, so you can concentrate on guiding the stroke alone.

• a defined width of cut instead of a random groove
• a repeatable result across several parts of the model
• a line that reads even once sprayed over with paint
• less risk of running off the line than with the point of a scalpel

Who it is for

For the modeler who has already tried scribing with improvised tools and keeps running into uneven grooves. The scriber is also a sensible first step toward gradually getting several widths and picking them according to the particular place on the model.

The tool is sharp. Work on a mat, guide the cut away from your body and protect the tip when putting it away, so that it is not knocked against other tools.