A modeling product in a 25 ml bottle, from the group of adhesives for plastic models. The way it is applied and the drying time are stated by the manufacturer on the packaging.
Responsibility details are not available.
A modeling product in a bottle of 25 ml from the group of adhesives for plastic models. The volume matches an ordinary working bottle: it lasts for a lot of work and at the same time takes up little room on the bench or in a toolbox. With a product like this the manufacturer's instructions on the packaging are binding, because they state the dosage, the setting time and which materials it is meant for.
Work in a well ventilated place and over a surface you do not mind soiling. Apply it in small doses, twice a little rather than once a lot; excess is hard to remove from smooth plastic and leaves a mark that you then have to sand and polish out. Remove dust and grease from the surfaces before joining them and let them dry. Try the effect first on an offcut or a piece of scrap plastic, so that you know how the surface reacts and how long the joint takes to set.
Close the bottle carefully right after work, or the contents of an opened package will thicken. Wipe the neck before closing so that the cap seats and opens easily next time. Store it dry and upright, away from frost and direct sunlight and out of reach of children.
What is supplied is the 25 ml bottle alone. Kits, paints, tools and other modeling products are not part of the delivery, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
