1:48 Yokosuka D4Y3/D4Y4 Suisei Control Surfaces is a Dead Design masking set for spraying the control surfaces of a model of this carrier dive bomber. It is not a kit.
Responsibility details are not available.
A set of self-adhesive masks for the control surfaces of a model of the late versions of the Japanese Yokosuka D4Y Suisei carrier dive bomber in 1:48 scale. Spraying over the masks creates shading that imitates the ribbed fabric frame of the ailerons and the rudder. The set complements the painting of a finished model.
The early versions of the D4Y had a liquid-cooled engine and a slender pointed nose. The D4Y3 and D4Y4 versions moved to a radial engine, so the nose widened and the overall silhouette of the aircraft changed markedly. For a modeler that is an important guide both in choosing a subject and in tracking down period photographs.
The commonest mistake with this type of mask does not come when applying it but when lifting it. If a mask is left on the model for a long time, the paint under its edge cures completely and a sharp edge breaks off as it is pulled away. Lift the masks therefore within tens of minutes of the last pass, while the film is still slightly pliable. Use fine-jawed tweezers or a pointed knife with which you only raise the corner of the mask, and then draw it off smoothly at a shallow angle back across itself. Remove any adhesive residue that is left with a dry cotton swab, not with a solvent.
The package holds masking material only. The model, paints and thinner are not part of it, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!