Photo-etched L-shaped brackets for the spare wheel holder for the Pz.Kpfw. III Ausf. J with Vorpanzer spaced armor, 1:35 scale, ten pieces in the package.
Responsibility details are not available.
This is not a kit but a photo-etched detail accessory for models of the medium tank Pz.Kpfw. III Ausf. J in 1:35 scale. According to the name the set contains ten L-shaped brackets that belong to the mounting of a spare road wheel on a vehicle with Vorpanzer spaced armor. Photo-etched sheet allows a thickness that cannot be produced in injection-molded plastic, so the mount really looks like a sheet-metal profile on a model rather than a thickened molding.
Spare road wheels were fixed to the hull by simple profile brackets. On a model this is a small but clearly visible element on the front of the vehicle, which with molded parts as a rule cannot be made to scale thickness. Ten pieces in the package cover several mounts or serve as a reserve when bending.
Cut the parts out of the fret with a sharp scalpel on a hard surface rather than with scissors, otherwise the sheet will ripple. Bend them in an etch bender or over a straight edge so that the bend is sharp and at a right angle. Glue them with cyanoacrylate applied in a minimal amount on the tip of a toothpick. Before painting, degrease the sheet and apply a primer intended for metal, otherwise the paint will not hold on the photo-etched part and will rub off during handling.
The accessory is supplied unassembled and unpainted. The base model, glue and paints are not included in the package, unless stated otherwise.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!
