The K17 is a hobby knife with a plastic body, built for delicate work: trimming decals, masks and films and cutting small parts free.
Responsibility details are not available.
A knife with a plastic body from the modeling range designated by the letter K. The lighter body is held more like a pencil than like a tool, which is exactly what delicate work calls for: the cut is led by the wrist and the fingers, not by the strength of the arm. The knife suits everywhere a minimum of material is removed and control over the point is what matters.
With decals the knife comes into its own twice. Before soaking, the excess carrier film is trimmed with it tight around the motif so that no glossy edge is visible on the surface once it has dried. And after application it is used to score carefully the places where the decal runs over an edge, a recess or an engraved line, and the score then lets the film settle instead of forming a bubble.
In this work you are cutting along the surface of the model, so a blunt edge will slip and leave a scratch in the finish; change the blade sooner rather than later. Lead the knife in short strokes and always away from the hand holding the work. Put a soft backing under a decal and under a film and make the cut in one stroke rather than going over it repeatedly.
For modelers who are finishing a surface and its markings and need a light, easily controlled tool for it. Leave heavier work, such as cutting thicker sections, to a more robust knife.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!