The double-sided set 1:32 Bf 109 E-3 Canopy Mask In And Out covers the cockpit frames from the outside and from the inside, so that the framing looks right even when you look into an open cockpit.
Responsibility details are not available.
The outer pieces come with counterparts for the inner side of the clear parts. The frames can then be colored in two different shades without your having to paint them in laboriously from both directions.
The real aircraft had the inside of the cockpit in a dark gray tone, while the camouflage of the fuselage continued on the outside. If the inner side is left out, bare clear plastic shows through the glazing and the cockpit looks unfinished. On the E-3 version, whose middle section hinges to the side and is often left open on a model, that difference is obvious at first glance. Close up, both sides of the frame also lie next to each other and the eye notices at once that one of them did not get any paint.
Start with the inner side: seat the counterparts, spray the shade of the cockpit and let it set. Then turn the part over, add the outer stencils and carry on with the primer and the camouflage. Only at the end take both sets off at once and check the edges against the light. A small run can be removed after curing with the tip of a wooden toothpick, whereas scratched glazing cannot be saved.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!