The mask 1:32 Hawker Hunter FGA.9 is cut for the windscreen and the hinged canopy of the British fighter-bomber; the target kit is given in the name of the item.
Responsibility details are not available.
The Hunter has an economically shaped cockpit: a low windscreen with vertical side panes and a hinged canopy with thin framing above it. It is exactly those thin frames that are treacherous when masking by hand, because a deviation of a tenth of a millimeter is enough to make the frame look thicker. Shaped pieces rule that mistake out.
The Hunter was created as a subsonic fighter with a jet engine and an elegant swept wing, and it became famous for exceptionally pleasant handling. The FGA.9 version came about as a conversion for attacks on ground targets: it received strengthened pylons and was used in warm regions, where it served long after more modern types had replaced it in Europe. It is also widely known thanks to its many export users.
The canopy is tall and harder to handle while masking; hold it by the edges, not by the surface, so that no greasy fingerprints are left on the glazing. Spray square to the surface, because with an angled stream the paint gets under the edge of a thin frame more easily than with a wide one. The side panes of the windscreen are almost vertical, so the paint runs on them readily; better twice lightly than once generously.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!