Flanges of 20 mm diameter in 1:35 scale for pipework, tanks and the industrial parts of dioramas.
Responsibility details are not available.
A flange is a circular collar with which pipes, tanks, hatches and fittings are joined in reality. On a model it has the same job as in engineering practice: an acknowledged joint is what tells the eye that pipework really is pipework and not a piece of tubing. In 1:35 scale the stated diameter of 20 mm corresponds to roughly 700 mm of real diameter, that is to a run of a genuinely large cross-section.
Industrial and harbor dioramas suggest themselves, along with refineries, boiler houses, pumping and transfer stations, the technical support areas of stations, or a demolition site where a broken run sticks out of the concrete. The flanges can also be used as the end of pipework that disappears into a wall and as the lid of a tank. They go well with brass tubing, with plastic profile and with tubing rolled from sheet. A longer run looks more natural when you place the joints at unequal intervals and do not line them up straight.
Cut away excess material and traces of manufacture with a sharp blade a little away from the part and sand the rest so that the part seats flat. Wash and degrease the surfaces before painting. Choose the glue according to the material of the part and of the groundwork. Apply the paint in thin layers, then bring the joint out with a dark wash around the circumference and a dry brush along the edges. Keep the beginnings of corrosion only where water runs down the metal.
Prepare your own paints, glue, tubing and base, unless stated otherwise. The exact procedure for preparation and gluing is given in the manufacturer's instructions.
Naši poradci a znalci sortimentu jsou připraveni odpovídat na Vaše dotazy (Po–Pá, 8–18 hod).
Zeptejte se na co potřebujete, odpovíme co nejdříve.
Texts from customers in the advice section reflect solely the opinions and views of the customers. MNF trade s.r.o. does not approve or verify customer texts in advance.
There are no questions here yet. Be the first to ask!